GenieACS not querying "non-reported" parameters

[jmeiring]

Seems this cane up before…

Any way to "force" setting a parameter value?

Situation here is the newest branch of a particular “Smart” CPE vendor firmware doesn’t report a parameter that actually exists. I know the parameter exists because if I dump the running config, I see the entry right where I would expect it. If I manually edit the data model in the DB and add the missing entry, I can set the value, and refresh the value. But until I manually create that entry (by hand editing the mongo data) I’m unable to make any changes. So is there anyway to force GenieACS …