Hi, I am new in genieacs. I tried to change the password of Wifi using genieacs. However, the password is shown to be changed in Genieacs GUI but it does not change in the CPE.
For example here I tried to update passphrase as prueba in CPE, but even after I updated it - it is the same as it was before.
How are you changing the passphrase? UI or NBI?
Check the logs on your CPE. If you have physical access, pop the cover and connect to the 4 pin serial header on the router, using serial settings of 115200 8n1. Most CPEs I’ve encountered output useful diagnostic data to the serial port. Data that is not usually captured in syslog.
The default password parameter is not displayed in the GUI, it appears blank, and when I click on configure and enter a new password, it is not executed and set in the CPE.
The password being blank is covered in the TR-069 documentation.
Did you click the “Commit” button after inputting your changes?
Yes, I click the Commit button and this runs normally, but the changes to the CPE are not made.
Hello, I just found the error with the password configuration sending, in the CPE parameters section I find this line of code: “InternetGatewayDevice.LANDevice.X.WLANConfiguration.X.RadiusServer”, how can I solve it, or what should I do?