Does anyone know how to use properly the simulator?
I have built a front end for the genie acs, I am using docker to run this image here GitHub - GeiserX/genieacs-docker: Automated configuration files for your GenieACS deployment , but I need to simulate an specific device to try running a few actions on it. But I had no success so far
Can anyone help?
The simulator is only wired out for limited test scenarios. Likely what you are trying to accomplish with the simulator is behavior that has not been written.
I am new to this Telecom area, if I need to perform actions with like Archer C5 W, firmware update, reboot, reset password. What do I need to do?
Read the GenieACS, TR069 and potentially TR-181 documentation. Then search this forum for any question you may have, your question has probably already been asked. Then if you still have technical questions, you can ask them here.