# About configuring acs url

**URL:** <https://forum.genieacs.com/t/about-configuring-acs-url/2497>\
**Category:** Uncategorized\
**Created:** [March 21, 2022, 5:38am UTC](https://forum.genieacs.com/t/about-configuring-acs-url/2497 "2022-03-21T05:38:52Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![kartish](https://avatars.discourse-cdn.com/v4/letter/k/278dde/32.png) [@kartish](https://forum.genieacs.com/u/kartish)\
**Post date:** [March 21, 2022, 5:38am UTC](https://forum.genieacs.com/t/about-configuring-acs-url/2497/1 "2022-03-21T05:38:52Z")

</div>

Hello, can we provide genieacs URL without going through management UI / router default gateway UI, Is there any other way we can give ACS URL without getting into the configuration page?

---

<div class="post-metadata">

**Author:** ![Andre\_Driemeyer](https://avatars.discourse-cdn.com/v4/letter/a/ed655f/32.png) [@Andre\_Driemeyer](https://forum.genieacs.com/u/Andre_Driemeyer)\
**Post date:** [March 21, 2022, 2:02pm UTC](https://forum.genieacs.com/t/about-configuring-acs-url/2497/2 "2022-03-21T14:02:37Z")

</div>

If your WAN connection is DHCP you can do this trough DHCP OPTION 60

> **[ACS Discovery | qa | cafe](https://www.qacafe.com/resources/acs-discovery/)**

Keep in mind it does not always work, I’ve seen partial implementations (tp-link) where the CPE would set the URL but would keep the ACS client turned off.

---

<div class="post-metadata">

**Author:** ![mtarifa](https://yyz1.discourse-cdn.com/flex035/user_avatar/forum.genieacs.com/mtarifa/32/848_2.png) [@mtarifa](https://forum.genieacs.com/u/mtarifa)\
**Post date:** [March 21, 2022, 3:57pm UTC](https://forum.genieacs.com/t/about-configuring-acs-url/2497/3 "2022-03-21T15:57:33Z")

</div>

Hello.

- The CPE must send the option 60 with the string ([dsl-forum.org](http://dsl-forum.org) or [broadband-forum.org](http://broadband-forum.org) depending if device1 or device2), and you should check that TR069 client is enabled over the WAN interface that you are using.
- DHCP server must send the ACS url (ip or fqdn with the proper tcp port like [http://10.0.0.1:1234](http://10.0.0.1:1234)) via Option43.1
- You need to add on the ACS the user/password for autentication if your are using one, because the CPE will send the one that is configured by default on firmware, or you need to change/configure one.

regards!